• Home
  • Stamping
  • Deep Draw
  • Fabrication
  • Tool & Die
  • Value Added Services
  • Quality Management
  • About Us
  • Careers
  • Contact
  • News
Engel Diversified Industries
  • Home
  • Stamping
  • Deep Draw
  • Fabrication
  • Tool & Die
  • Value Added Services
  • Quality Management
  • About Us
  • Careers
  • Contact
  • News

SLASHING CHANGEOVER TIMES!

Servo Press-2.jpg

Our new feed line has an automatic peeler, traveling coil car, and threading table, which greatly reduce coil change time. With increased coil size capacity, we reduce the number of coil changes needed, thereby increasing production up time up to two fold.

Our controller stores 200 job “recipes,” including parameters such as shut height, stroke profile, coil feed length, material straightener settings, and die protection settings – not only saving setup time, but insuring run-to-run consistency.

With programmable reduced stroke, our press is easily opened to full stroke with full control of ram speed and location to within .004” through the hand wheel, while maintaining full tonnage, to allow for improved debugging and in-press tool maintenance.

Monday 10.14.19
Posted by Ben Kalow
Newer / Older